RE: Config LMI to use DLCI 0

From: Daniel Hong (Daniel.Hong@xxxxxxxxxx)
Date: Sun Nov 18 2001 - 23:14:16 GMT-3

• Next message: Daniel Hong: "32bits Mask on Ethernet Int"
• Previous message: lgao: "DLSW mac address filter"
• Maybe in reply to: Daniel Hong: "Config LMI to use DLCI 0"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Thanks Erick . I think this is what the question asked for.

Daniel

-----Original Message-----
From: Erick B. [mailto:erickbe@yahoo.com]
Sent: 19/11/2001 11:28
To: Daniel Hong; ccielab@groupstudy.com
Subject: Re: Config LMI to use DLCI 0

Hi,

Annex A Q.933 and Annex D T1.617 use 0 for their
Control DLCI. You change the LMI type to one of the
above to use 0. The router and frame switch have to be
configured for the same type to talk.

I hope this is what you were looking for...

Erick

--- Daniel Hong <Daniel.Hong@nec.com.au> wrote:
> Hi,
>
> How to config lmi to use DLCI 0 for signalling?
>
> Thx in advance
>
> Daniel

• Next message: Daniel Hong: "32bits Mask on Ethernet Int"
• Previous message: lgao: "DLSW mac address filter"
• Maybe in reply to: Daniel Hong: "Config LMI to use DLCI 0"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:18 GMT-3