From: Robert Miller (rmiller@xxxxxxxxxxxx)
Date: Sat Nov 17 2001 - 22:49:00 GMT-3
Sanjay,
Those intervals are for the routers to achieve FULL
neighbor status. It does not affect all interfaces in an area,
only those that are connected (ie serial interfaces).
If you also connected the ethernet interfaces,
those intervals would then have to match, but still independant
of the serial interfaces.
Robert Miller, CNE, MCSE, CCNE
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
sanjay
Sent: Saturday, November 17, 2001 7:00 PM
To: ccielab@groupstudy.com
Subject: OSPF question
I have 2 routers connected back to back serially. Both routers have ethernet
interfaces and both routers are running OSPF, all intefraces belong to the
same area. If I change the transmit interval delay and hello interval on the
serial interfaces that connect the 2 routers, do I need to change this on
all
interfaces ?
What I am trying to get to is that in OSPF, does all interface in the
common
area should be have the same hello and transmit delay settings or is it only
the interfaces that are involved (in this case the serial interfaces on both
routers)?
thanks,
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:17 GMT-3