From: Bryan Ginman (ginmanb@xxxxxxxxxxx)
Date: Wed Nov 14 2001 - 14:19:25 GMT-3
Section 2 Task 2 states "configure ISIS type 1 between R5 and R14 " Yet in
Task three it states to redist OSPF into ISIS as Type 2. That's fine but on
the solutions routing table for R5 has L2 routes in it from OSPF??????? I
checked the corrections on there page but didn't see anything for this one,
if its a Level 1 circuit between R5 - R14 this can't be. Any help I'm
assuming its a typo and should just be a Level-1-2 circuit.
Also when redistributing ISIS into OSPF the connected interfaces don't show
up unless you explicitly redist them, Am I missing something because on the
solutions routing table in OSPF shows these interfaces/subnets redistributed
in, yet no redist of connected interfaces has been entered on the ABR.
Cheers,
Bryan
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:15 GMT-3