anycast

From: Wayne Lewis (lewisway@xxxxxxxxxxxxxx)
Date: Tue Nov 13 2001 - 22:10:14 GMT-3

• Next message: F B: "RE: Flash issue??!!"
• Previous message: Hansang Bae: "Re: EIGRP advertisement"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
        At the site http://www.cisco.com/warp/public/cc/pd/iosw/tech/rppim_rg.h
tm,
if you look at the AnycastAuto-RPsparse-mode configurations (under 10.),
they use the command 'ip pim rp-announce-filter group-list 1' on
non-RP-mapping agents. CCO says that this command is used on mapping
agents. Do any of you multicasting afficionados have an explanation for the
role of this command as used in this example? Is it a mistake?

        Thanks,

          Wayne

• Next message: F B: "RE: Flash issue??!!"
• Previous message: Hansang Bae: "Re: EIGRP advertisement"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:15 GMT-3