From: Church, Chuck (cchurch@xxxxxxxx)
Date: Fri Oct 26 2001 - 14:06:10 GMT-3
Try setting the serial port on your PC (assuming it's Windows) to not use
FIFO buffers. One of my older 2500s did the same thing until I did this.
The setting is under advanced, I believe. HTH...
Chuck
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Ahmed Mamoor Amimi
Sent: Friday, October 26, 2001 11:24 AM
To: Ccielab
Subject: 3 router same problem and not yet solved.
Hi,
Lets see who can crack this !!
This topic is discussed many time but i didn't get any answer then solved my
problem,anyhow I have 3 routers , two 4500 and one 4700 . non of the console
works. When i power-on the routers they give me the booting on the console
but at the end where i have to start it dont accept anything. All of my
routers gets this problem with in a week. I have applied the following
solution.
1- ram change
2- flash change
3- baudrate change
4- flow control none
5- scrollock toggle
6- hitting space bar at booting to get in to ROMMON
7- nothing on AUX port, dont see anything there too. (This is just because
router didnt finshed booting as the router is on
asking for the initial config.)
8- plugging in and out rapidily when booting.
9- tried hyperterminal, secureCRT, tera term
10- changed the console cable and converters at the ends.
Any more solution from the group... lets see...
-Mamoor
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 22:33:25 GMT-3