From: Ahmed Mamoor Amimi (mamoor@xxxxxxxx)
Date: Tue Oct 30 2001 - 11:02:19 GMT-3
I have tried this also but didnt help.
feed me more suggestions.... please.
-Mamoor
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Church, Chuck
Sent: Friday, October 26, 2001 10:06 PM
To: 'Ahmed Mamoor Amimi'; 'Ccielab'
Subject: RE: 3 router same problem and not yet solved.
Try setting the serial port on your PC (assuming it's Windows) to not use
FIFO buffers. One of my older 2500s did the same thing until I did this.
The setting is under advanced, I believe. HTH...
Chuck
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Ahmed Mamoor Amimi
Sent: Friday, October 26, 2001 11:24 AM
To: Ccielab
Subject: 3 router same problem and not yet solved.
Hi,
Lets see who can crack this !!
This topic is discussed many time but i didn't get any answer then solved my
problem,anyhow I have 3 routers , two 4500 and one 4700 . non of the console
works. When i power-on the routers they give me the booting on the console
but at the end where i have to start it dont accept anything. All of my
routers gets this problem with in a week. I have applied the following
solution.
1- ram change
2- flash change
3- baudrate change
4- flow control none
5- scrollock toggle
6- hitting space bar at booting to get in to ROMMON
7- nothing on AUX port, dont see anything there too. (This is just because
router didnt finshed booting as the router is on
asking for the initial config.)
8- plugging in and out rapidily when booting.
9- tried hyperterminal, secureCRT, tera term
10- changed the console cable and converters at the ends.
Any more solution from the group... lets see...
-Mamoor
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 22:33:28 GMT-3