From: John Elias (jelias_@xxxxxxxxxxx)
Date: Fri Oct 26 2001 - 11:35:26 GMT-3
You need a dialer-group on R6 permitting ip.
John E.
CCIE #8150
>From: "Church, Chuck" <cchurch@USTA.com>
>Reply-To: "Church, Chuck" <cchurch@USTA.com>
>To: "'kevin@btamail.net.cn'" <kevin@btamail.net.cn>,
>"'ccielab@groupstudy.com'" <ccielab@groupstudy.com>
>Subject: RE: Ping doesn't work on isdn!!!
>Date: Fri, 26 Oct 2001 10:16:07 -0400
>
>Kevin,
>
> Since the source IP is 10.1.1.6, I assume you're pinging from R6 to
>R7. But you don't have a dialer map statement on R6. 'Sh dialer map'
>should verify this.
>
>Chuck
>
>-----Original Message-----
>From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
>kevin@btamail.net.cn
>Sent: Friday, October 26, 2001 9:25 AM
>To: ccielab@groupstudy.com
>Subject: Ping doesn't work on isdn!!!
>
>
>Hello all, I config ppp multilink on router with isdn port. isnd
>established
>successfully. But ping
>doesn't work. I debug ip packet. The following is shown:
>02:06:31: IP: s=10.1.1.6 (local), d=10.1.1.7 (BRI0), len 100, sending
>02:06:31: IP: s=10.1.1.6 (local), d=10.1.1.7 (BRI0), len 100, encapsulation
>fail
>ed
>Two router configuration for isdn as following:
>r7#sh run int b0
>Building configuration...
>Current configuration:
>!
>interface BRI0
> ip address 10.1.1.7 255.255.255.0
> no ip directed-broadcast
> encapsulation ppp
> shutdown
> dialer idle-timeout 300
> dialer map ip 10.1.1.6 name r6 1111111
> dialer load-threshold 128 outbound
> dialer-group 1
> isdn switch-type basic-net3
> no peer neighbor-route
> ppp multilink
>end
>r6#sh run int b0
>Building configuration...
>Current configuration:
>!
>interface BRI0
> ip address 10.1.1.6 255.255.255.0
> no ip directed-broadcast
> encapsulation ppp
> dialer idle-timeout 300
> isdn switch-type basic-net3
> no peer neighbor-route
> ppp multilink
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 22:33:25 GMT-3