From: John Kim (albugkim@xxxxxxxxxxx)
Date: Fri Oct 26 2001 - 11:27:16 GMT-3
Kevin,
The bri0 interface on your r7 router is shutdown. Bring the interface up
first. If you still have problems, please post the full configurations for
both routers?
Thanks,
John Kim
>From: "Richard Foltz" <ccie2b@rfoltz.com>
>Reply-To: "Richard Foltz" <ccie2b@rfoltz.com>
>To: <kevin@btamail.net.cn>, <ccielab@groupstudy.com>
>Subject: Re: Ping doesn't work on isdn!!!
>Date: Fri, 26 Oct 2001 09:01:09 -0500
>
>turn on ppp authentication. make sure u put in the username/password
>combos.
>
>Richard Foltz, CCNP-Voice, CCDP, MCSE+I, Network+, A+
>RTP 11/2-3
>
>
>----- Original Message -----
>From: <kevin@btamail.net.cn>
>To: <ccielab@groupstudy.com>
>Sent: Friday, October 26, 2001 8:25 AM
>Subject: Ping doesn't work on isdn!!!
>
>
> > Hello all, I config ppp multilink on router with isdn port. isnd
>established successfully. But ping
> > doesn't work. I debug ip packet. The following is shown:
> > 02:06:31: IP: s=10.1.1.6 (local), d=10.1.1.7 (BRI0), len 100, sending
> > 02:06:31: IP: s=10.1.1.6 (local), d=10.1.1.7 (BRI0), len 100,
>encapsulation fail
> > ed
> > Two router configuration for isdn as following:
> > r7#sh run int b0
> > Building configuration...
> > Current configuration:
> > !
> > interface BRI0
> > ip address 10.1.1.7 255.255.255.0
> > no ip directed-broadcast
> > encapsulation ppp
> > shutdown
> > dialer idle-timeout 300
> > dialer map ip 10.1.1.6 name r6 1111111
> > dialer load-threshold 128 outbound
> > dialer-group 1
> > isdn switch-type basic-net3
> > no peer neighbor-route
> > ppp multilink
> > end
> > r6#sh run int b0
> > Building configuration...
> > Current configuration:
> > !
> > interface BRI0
> > ip address 10.1.1.6 255.255.255.0
> > no ip directed-broadcast
> > encapsulation ppp
> > dialer idle-timeout 300
> > isdn switch-type basic-net3
> > no peer neighbor-route
> > ppp multilink
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 22:33:25 GMT-3