From: Thomas, Varghese (vnthomas@xxxxxxxxxxx)
Date: Fri Oct 26 2001 - 10:45:45 GMT-3
Hello Louie,
U r absolutely right; it was caused by my IPSEC client.
Thanks a lot for ur help
Tx n RD
----- Original Message -----
From: "louie kouncar" <lkouncar@UU.NET>
To: "'Matt Wagner'" <miguknom@hotmail.com>; <vnthomas@hotmail.com>;
<ccielab@groupstudy.com>
Sent: Thursday, October 25, 2001 2:45 PM
Subject: RE: Simple pinging problem
> Do you have any kind of firewall on the PC?
>
>
>
> Louie J. Kouncar CCIE #7994
>
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> Matt Wagner
> Sent: Thursday, October 25, 2001 2:20 PM
> To: vnthomas@hotmail.com; ccielab@groupstudy.com
> Subject: Re: Simple pinging problem
>
>
> Do you have an ARP cache problem?
>
>
>
> ----Original Message Follows----
> From: "Thomas, Varghese" <vnthomas@hotmail.com>
> Reply-To: "Thomas, Varghese" <vnthomas@hotmail.com>
> To: <ccielab@groupstudy.com>
> Subject: Simple pinging problem
> Date: Thu, 25 Oct 2001 14:14:53 -0400
>
> Hello folks,
>
> I connected a cross LAN cable between router's ethernet port and my
> PC(win2K);
> Problem is, I can NOT ping PC from router end, but I can ping the Router
> from PC end.
>
> router ip - 172.16.10.65/26 & PC's IP: 172.16.10.67/26
>
> Router's Sh arp command shows my PC's MAC & IP address correctly(I can
very
> well see it from deb arp as well)
>
> When I turned on, debug ip packet, I can see the packets are being sent to
> ethernet interface, but it is not reaching my PC(as I don't see it in my
> PC's
> arp table) and nothing comes up in my sniffer.
>
> When I ping from PC, I can see correct ip packet sequences from router's
> debug
> output.
>
> I can even, telnet to the router from my PC via this cross cable, but
again,
> pinging from the telenet session still fails.
>
> I do not see any output from deb ip icmp while I ping from router, but
shows
> usual output when I ping from PC.
>
> Router do not have any special config and even I brought down all routing.
>
> When I replace my PC with another router(with the same cross cable), it
> works
> fine.
>
> I tried with different router models/ios and shows the same result.
>
> Any hints!!!
>
>
> Tx n RD
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 22:33:25 GMT-3