From: andrew.2.shore@xxxxxx
Date: Fri Oct 26 2001 - 04:38:10 GMT-3
I have had this problem several times with W2K.
Solution : Reinstall the network card driver and IP stack on W2K; hey Presto
it works.
I'm sure XP fixes this problem :) or perhaps the next MS OS !
Andrew Shore. CCNP+Security, MCSE, CCP, BSc
Network Consultant
Internetworking Solutions Limited
-----Original Message-----
From: Thomas, Varghese [mailto:vnthomas@hotmail.com]
Sent: 25 October 2001 19:15
To: ccielab
Subject: Simple pinging problem
Hello folks,
I connected a cross LAN cable between router's ethernet port and my
PC(win2K);
Problem is, I can NOT ping PC from router end, but I can ping the Router
from PC end.
router ip - 172.16.10.65/26 & PC's IP: 172.16.10.67/26
Router's Sh arp command shows my PC's MAC & IP address correctly(I can very
well see it from deb arp as well)
When I turned on, debug ip packet, I can see the packets are being sent to
ethernet interface, but it is not reaching my PC(as I don't see it in my
PC's
arp table) and nothing comes up in my sniffer.
When I ping from PC, I can see correct ip packet sequences from router's
debug
output.
I can even, telnet to the router from my PC via this cross cable, but again,
pinging from the telenet session still fails.
I do not see any output from deb ip icmp while I ping from router, but shows
usual output when I ping from PC.
Router do not have any special config and even I brought down all routing.
When I replace my PC with another router(with the same cross cable), it
works
fine.
I tried with different router models/ios and shows the same result.
Any hints!!!
Tx n RD
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 22:33:25 GMT-3