From: Nigel Taylor (nigel_taylor@xxxxxxxxxxx)
Date: Fri Sep 14 2001 - 20:13:46 GMT-3
Steve,
Using the "basic-ni" isdn switch-type requires you to have spids
configured. I'm sure a quick check of your "sh isdn status" show that L2
is not active. CCO has some good examples of basic ISDN configurations..
HTH
Nigel..
>From: "Steve Barone" >Reply-To: "Steve Barone" >To:
ccielab@groupstudy.com >Subject: ISDN Overview - Caslow p173 >Date: Fri,
14 Sep 2001 15:23:17 -0400 > >Folks, >I am not able to figure this one
out: >Cannot ping to 10.1.1.2 from R1, sh dialer and all link >layer
stuff is up. > >Thanks, > >R1 >int bri0 > ip addr 10.1.1.1 255.255.255.0
> encap ppp > dialer map ip 10.1.1.2 5551212 > isdn switch-type basic ni
> dialer-group 1 > >dialer-list 1 protocol ip permit > > >R2 >int bri0 >
ip addr 10.1.1.2 255.255.255.0 > encap ppp > isdn switch-type basic ni >
dialer-group 1 > >dialer-list 1 protocol ip permit >**Please
read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:18 GMT-3