From: Arnold Ocasio (aocasio@xxxxxxxxx)
Date: Fri Sep 14 2001 - 16:42:19 GMT-3
Where are the spid numbers? You are using NI for switch type which requires
spid numbers.
Regards,
============================================================================
Arnold Ocasio .. .. Cisco Systems, Inc.
Network Consulting Engineer || || 7025 Kit Creek Road
Advanced Network Services || || Lake Building
Phone: (919)392-4717 || || PO Box 14987
Fax: (919)392-5758 !||! !||! RTP, NC 27709
Pager: (800)365-4578 ...:||||||:...:||||||:... Main: (800)888-8187
aocasio@cisco.com c i s c o S y s t e m s www.cisco.com
"Empowering the Internet Generation"
============================================================================
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Steve Barone
Sent: Friday, September 14, 2001 3:23 PM
To: ccielab@groupstudy.com
Subject: ISDN Overview - Caslow p173
Folks,
I am not able to figure this one out:
Cannot ping to 10.1.1.2 from R1, sh dialer and all link
layer stuff is up.
Thanks,
R1
int bri0
ip addr 10.1.1.1 255.255.255.0
encap ppp
dialer map ip 10.1.1.2 5551212
isdn switch-type basic ni
dialer-group 1
dialer-list 1 protocol ip permit
R2
int bri0
ip addr 10.1.1.2 255.255.255.0
encap ppp
isdn switch-type basic ni
dialer-group 1
dialer-list 1 protocol ip permit
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:18 GMT-3