From: Philippon (jaywilphil@xxxxxxxxx)
Date: Thu Sep 13 2001 - 14:14:23 GMT-3
I am not sure if this will fully complete your
objective but, make two standby groups on the routers
and make one the master on each. You would have to
make the P.C.'s gateway on the LAN's to match with
router you want to use. This should work and I believe
there is an example in the LAN Switching Book.
Hope it helped.
--- "McHie, Anthony"
<anthony.mchie@corp.bellsouth.net> wrote:
> Hey gang,
>
> Here is my question:
> How do you get an HSRP master to make use of the
> circuit on the HSRP standby
> router? The circuits are low bandwidth full-duplex.
> The desired state is
> to have both circuits utilized for both TX and RX.
> I'm open to route-maps,
> routing protocols, or any other means. Thanks
>
> Current State
> ------------------
> HSRP 10.3.0.3
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:16 GMT-3