From: Bill Carter (bcarter@xxxxxxxxxxxxxx)
Date: Thu Sep 13 2001 - 12:53:58 GMT-3
Run a crossover cable between the HSRP master and standby routers.
^-^-^-^-^-^-^-^-^-^-^
Bill Carter
CCIE 5022
^-^-^-^-^-^-^-^-^-^-^
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
McHie, Anthony
Sent: Thursday, September 13, 2001 10:07 AM
To: ccielab@groupstudy.com
Subject: HSRP load sharing with redundant circuits
Hey gang,
Here is my question:
How do you get an HSRP master to make use of the circuit on the HSRP standby
router? The circuits are low bandwidth full-duplex. The desired state is
to have both circuits utilized for both TX and RX. I'm open to route-maps,
routing protocols, or any other means. Thanks
Current State
------------------
HSRP 10.3.0.3
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:16 GMT-3