From: Raji Mohan (raji@xxxxxxxxxxxxxxxx)
Date: Thu Sep 13 2001 - 12:33:05 GMT-3
Hi,
Please post your configs. Additionally you might want to check and ensure
that the kind of intf match on both ends bcos ISIS does not have any kind
of cmd similar to 'ip ospf network <type> ' to match hellos. So if you
have point-to-pt intf on one end , the other end also has to be the same.
Check and email ur config.
/raji
On Thu, 13 Sep 2001 jonatale@earthlink.net wrote:
> There was a big discussion on this mailing list about 3 weeks ago -- I think
> basically ISIS can only work over p2p and bcast/full-mesh, not over
> NBMA/partial-mesh/hub-spoke.
> ccielab@groupstudy.com
>
>
>
> Piperw222@aol.com wrote:
>
> > Can anyone please post working configs for ISIS over Frame relay... Please
> > let me know the configs for sub interface on the hub as well as without. I
am
> > having problems forming an adjacency over the Frame relay cloud. I need a
> > very simple config for hub and spoke...
> >
> > I am also getting problems when configuring the area address and system id
-
> > I wanted to use the address of the Ethernet put when posted it into the
> > router I got the following error message.
> >
> > %CLNS: System ID (0000.E01E.3E8C.00) must not change when defining addition
al
> > area addresses
> >
> > Thanks,
> >
> > Lou
> > **Please read:http://www.groupstudy.com/list/posting.html
> **Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:16 GMT-3