From: Jason Sinclair (sinclairj@xxxxxxxxxxxxxxx)
Date: Tue Aug 14 2001 - 01:28:18 GMT-3
If you have the following setup:
Loopback(10.0.2.1/24)routerA(10.0.0.1/30)-------------------(10.0.0.2/30)rou
terB
As we all know running RIPv1 between the two you cannot ping 10.0.2.1 from
routerB('cause the mask is longer). What would be the correct solution to
make this happen? I have a couple:
1. Put a static route 10.0.2.0 255.255.255.0 10.0.0.1 (on routerA)
2. Put a static route 10.0.2.0 255.255.255.252 loopback 0 and redistribute
connected on routerB. This will add the 10.0.2.0 route to routerA routing
table via RIP.
Note however that if you do step 2 above but route via null0, this will not
work as the more specific route (10.0.2.0/30) over-rides the /24 and the
packets are discarded. Anyone know other ways to do this?
Regards.
Jason Sinclair
Team Leader - NSG
POWERTEL Limited
Level 11, 55 Clarence Street, SYDNEY
Phone: 61-2-8264-3820
Mobile: 0416 105 858
jasons@powertel.net.au
**********************************************************************
This email (including all attachments) is intended solely for the named
addressee. It is confidential and may contain commercially sensitive
information. If you receive it in error, please let us know by reply email,
delete it from your system and destroy any copies.
This email is also subject to copyright. No part of it should be reproduced,
adapted or transmitted without the prior written consent of the copyright owner
.
Emails may be interfered with, may contain computer viruses or other defects
and may not be successfully replicated on other systems. We give no
warranties in relation to these matters. If you have any doubts about
the authenticity of an email purportedly sent by us, please contact us
immediately.
**********************************************************************
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:31:50 GMT-3