From: Lachlan Kidd (lkidd@xxxxxxxxxxxxxxxxxxx)
Date: Wed Aug 08 2001 - 20:23:00 GMT-3
Hi Louie,
Not wanting to be smartass but....have you considered the 'dynamic'
keyword. Check out page 3-19 in the DLSW design guide.
HTH,
Lachlan
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
louie kouncar
Sent: Thursday, 9 August 2001 8:54 AM
To: ccielab@groupstudy.com
Subject: DLSW question from CCbootcamp lab 19
All,
In lab 19 Task Two (Advanced DLSW Configuration), question number 5 states
the following:
Configure R6 for DLSW, configure a static resource for MAC address
4444.3333.2222. R2 is the only router that should have a DLSW connection to
R6
Make sure that this connection is dynamic and only comes up if there is an
explorer destined for 4444.3333.2222....
Here is what I did:
R6 (config):
dlsw local-peer peer-id 140.4.6.1 promiscuous
dlsw icanreach mac-exclusive
dlsw icanreach mac-address 4444.3333.2222 mask ffff.ffff.ffff
R2 (config):
dlsw local-peer peer-id 140.4.2.1
dlsw remote-peer 0 tcp 140.4.6.1
The problem is that the (show dlsw peers) command on R2 shows (CONNECT ALL
THE TIME), What am I missing??????????
TCP 140.4.6.1 CONNECT 43 43 conf 0 0 0
00:18:03
I am not sure what to do to make this a dynamic connection that comes up
only if needed (Per question).
Any help is appreciated....
Louie J. Kouncar
TCO3 Senior Data Center Engineer
WorldCom Web Hosting (Tysons)
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:31:47 GMT-3