From: Jay Chandradas (jachandr@xxxxxxxxx)
Date: Tue Aug 07 2001 - 12:09:34 GMT-3
Auto RP :
I am trying to configure Auto RP in a FR mesh.
r1-----------------------------r2--------------------------r3
r2 is my hub router. I have loop back configured in all the routers and i
have an ip connectivity between all these routers. I have configured r3
as my auto rp. using
at r3:
ip pim send-rp-announce loop back 0 scope 16
ip pim sparse-mode
r2:
ip pim sparse mode
ip pim nbma mode
r1:
ip pim sparse-mode
ip igmp join-gr 224.0.0.10
and configured r1 to join the multicast group .. say 224.0.0.10
Q1: is that all needed to configure ? auto-rp .. I am able to ping this
multicast group .. Just wanted to confirm.
Q2: I have added ip pim nbma mode on the hub router. Is this configuration
necessary ? I am able to ping my m-cast even without that.. Doc CD says to
use a ip pim nbma mode. I am not sure if I need to add this command in all
the NBMA interfaces.
Some one who tried to configure the auto rp in nmba network can please help
me to confirm that I am doing the right procedure.
TIA
Jay.
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:31:46 GMT-3