From: Chuck Church (cchurch@xxxxxxxxxxxx)
Date: Mon Jul 02 2001 - 00:03:13 GMT-3
Yeah, the 3600 routers are a pain when it comes to finding a release that
supports all the different modules. Many modules don't have a mainline,
much less a GD release that support them. I know the NM-2FE2W doesn't.
Until 12.2.1. Not quite ready to install that anywhere, though!
Chuck
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Ramesh Ramasamy
Sent: Sunday, July 01, 2001 10:32 PM
To: cchurch@MAGNACOM.com; knafie@ncr.com.kw; ccielab@groupstudy.com
Subject: RE: HSRP- I hate bugs
Chuck,
I always like the GD...But..
The c3640-jk2s-mz.121-5.T7.bin has a bug of tcp - with the vpn hw--so
TAC recommended the c3640-jk2s-mz.121-5.T8.bin
I found this new problem on this! Didnt get the time to investigate with
TAC yet.
If you have the vpn accel module and the 12-1-5-T7 then you cant even
bring up the tunnel - you have to disable the module through ios and you
can see that the tunnel comes up then!!
Regards,
Ramesh.
>From: Chuck Church <cchurch@MAGNACOM.com>
>To: Ramesh Ramasamy <ramesh_ramasamy@hotmail.com>, knafie@ncr.com.kw,
>ccielab@groupstudy.com
>Subject: RE: HSRP- I hate bugs
>Date: Sun, 1 Jul 2001 22:18:14 -0400
>
> That's why they're labeled 'T' versions. If you want to avoid bugs,
>go with the GD releases:
>http://www.cisco.com/warp/customer/417/109.html
>
> Of all the Cisco releases, the 'T' versions are usually ED, which
>are the newest and least tested. TAC will tell you, stick with GD!
>
>Chuck
>
>12.1.5T8 - Sounds like you're trying to do PPTP!
>
>
>
>
>-----Original Message-----
>From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
>Ramesh Ramasamy
>Sent: Sunday, July 01, 2001 11:40 AM
>To: knafie@ncr.com.kw; ccielab@groupstudy.com
>Subject: Re: HSRP- I hate bugs
>
>
>Khalid,
>I have a similar experience - 12.1.5 T8 - with 3DES -HSRP/tracking/etc.,
>I noticed that I crash the ios when i forget to put the same standby group
>#
>
>and try to add a standby ... command !!! on the 2620.
>Luckily, my setup was for pre-production testing !! I know this now - so
>when it is being brought up ! I will ensure that i dont do the simple
>mistake!
>Anyone aware of any specific bug id?
>Thanks,
>Ramesh.
>
>
> >From: Khalid Nafie <knafie@ncr.com.kw>
> >Reply-To: Khalid Nafie <knafie@ncr.com.kw>
> >To: "Ccielab (E-mail)" <ccielab@groupstudy.com>
> >Subject: HSRP- I hate bugs
> >Date: Sun, 1 Jul 2001 01:28:20 +0300
> >
> >Hi guys,
> > i configured HSRP with authentication the funny thing is that after
> >I configured one side with auth it worked although the other side is not
> >conf for auth yet, then I put different password on the other side, and
> >thanks god there was a message stating that bad authentication, but every
> >thing was working fine and they know about each other, further more I
> >shutdown the tracked interface at the active peer so its priority
>decreased
> >and the other peer took over, I don't know what kind of authentication is
> >this?
> >hopefully someone has similar experience
> >
> >================================================
> >Yours,
> >Khaled Nafie
> >Network Engineer
> >Customer Services
> >MCSE,CCDP,CCNP VOICE ACCESS
> >NCR Corporation, Kuwait
> >Mob.: +965-9872046
> >Tel : +965- 2412201, 2412203
> >Fax : +965-2413075
> >**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:31:28 GMT-3