From: Theodore TZEVELEKIS (theodore_tzevelekis@xxxxxxxxx)
Date: Sun Jun 17 2001 - 11:54:57 GMT-3
dialer watch will check the existance of a certain route in your routing
table. If it dissappears, it activates the link.
That's all it does.
The debug message is probably due to some routing protocol or other process
that sends packets to an IP address different than the one specified in you
dialer map statement.
Theo
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
jack chen
Sent: Sunday, June 17, 2001 4:33 PM
To: ccielab@groupstudy.com
Subject: dialer watch's interesting packet
Hello,
I'm working with dialer-watch backup for OSPF.
It say that dialer-watch don't need intersting
packet,right?
But my config is not work ,the debug information
told me 'no dialer map/string present in bri0
interface'
interface BRI0
ip address 10.10.1.3 255.255.255.0
encapsulation ppp
dialer idle-timeout 60
dialer map ip 10.10.1.2 name r2 broadcast 53511676
dialer hold-queue 50
dialer watch-group 1
dialer-group 1
isdn switch-type basic-net3
ppp authentication chap
access-list 101 deny ip any host 255.255.255.255
access-list 101 permit ip any any
dialer watch-list 1 ip 10.2.2.0 255.255.255.0
dialer-list 1 protocol ip list 101
Why?
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:31:25 GMT-3