From: Jeff K. (jeffbk@xxxxxxxxxxxxx)
Date: Thu Jun 14 2001 - 21:47:16 GMT-3
Are you sure that line 1 is the aux port? The aux port should be the last
line # (after the tty lines). I don't have a 3620, but on the 2511 the aux
is line # 17. Do a 'sh line' to be sure... It might be line 65.
HTH
----- Original Message -----
From: "Jubil Mathew" <jmathew@cisco.com>
To: "Chuck Church" <cchurch@MAGNACOM.com>
Cc: "Padhu (LFG)" <padhu@steinroe.com>; <ccielab@groupstudy.com>
Sent: Thursday, June 14, 2001 7:40 PM
Subject: RE: Routing protocols over Async
> Hi,
>
> I am not able to get to the interface async 1 part configured.
> Is this supported in all IOS images. I am getting the following errors.
>
> 3620-2#conf t
> 3620-2(config)#line aux 0
> 3620-2(config-line)# modem InOut
> 3620-2(config-line)# transport input all
> 3620-2(config-line)# rxspeed 38400
> Failed to change line 65's speed
> 3620-2(config-line)# txspeed 38400
> Failed to change line 65's speed
> 3620-2(config-line)# flowcontrol hardware
> 3620-2(config-line)#
>
>
> 3620-2(config)#int as?
> Async
>
> 3620-2(config)#int async ?
> <1-65> Async interface number
>
> 3620-2(config)#int async 1 ?
> % Unrecognized command
> 3620-2(config)#int async 1
>
> what is to be done next. Is this the proper way to configure aux ports.
>
> regards
> Jubil Mathew
> Software Engineer, MPSBU
> Cisco Systems Inc.
> 821, Alder drive, SJ-22/2/1
> Milpitas, California. 95035
> Phone: (408) 853-4566
> jmathew@cisco.com
> **Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:31:24 GMT-3