From: Jason Gardiner (gardiner@xxxxxxxxxx)
Date: Thu Jun 07 2001 - 13:54:29 GMT-3
The Bandwidth statement is also used to determine the Load stats in "sh
int". If it is set for, say 64 on a circuit that is clocked at 1544,
then the load on the circuit can be greater than 255/255.
That being the case, wouldn't the erroneous load cause issues with IGRP
and EIGRP, assuming that the load metric is used?
"Martin, Chris" wrote:
>
> comments are below:
>
> ----- Original Message -----
> From: "Rajeev Siddappa" <raj_lab@yahoo.com>
> To: <ccielab@groupstudy.com>
> Sent: Thursday, June 07, 2001 9:03 AM
> Subject: Bandwidth Vs. Clockrate.
>
> > Hi evry one,
> >
> > Consider a test lab environemnt, where I am using Back
> > to back (DTE to DCE) serail cales to connect between
> > routers.
> >
> > 1. If I change the bandwidth from 1.544 Mb to 64 Mbps
> > will it affect the physical interace or will it
> > only afftect the routing protocol. I belive that it
> > only affects the routing protocol in computing &
> > selting the right path. but the data will be pushed at
> > the maximum avilable bandwidth.
>
> Changing the bandwidth only effects the routing protocol. How would it
> effect the physical interface? You mean i could change the bandwidth
> statement on my isdn link at home from 128k to 45mb and have a OC 3 to the
> internet??
>
> >
> >
> > 2. If I change the clock rate, we are physically
> > changing the rate at which the data is pushed on the
> > interface, so it will have the right effet on the
> > interface.
> >
> Thats right, if the clock rate is 64000 your running at 64k if its 500000
> your running at 500k
> >
> > Please correct me if I am wrong. Need u commets.
> >
> > Thanks,
> > Rajeev.
> >
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:31:20 GMT-3