From: Rahmlow, Howard F. (howard.rahmlow@xxxxxxxxxx)
Date: Tue May 29 2001 - 13:47:13 GMT-3
Check the archives from about 6 months ago. There was a very long thread on
the same issue. The end result was, no you can not get the box serial number
from any IOS or snmp commands.
Howard
-----Original Message-----
From: glange@libero.it [mailto:glange@libero.it]
Sent: Tuesday, May 29, 2001 12:10 PM
To: ccielab@groupstudy.com
Subject: Serial-Numbers
Hello,
if I make on a Catalyst Switch a "sh version" or "sh module" I can see
all Serial-Numbers of the installed modules.
With the command "sh version" on a Cisco router there will be only
displayed a "Processor board ID .... ", that is not the same as the
Serial-Number.
I've heard, that the "Processor board ID" of the router was some
years ago the S/N.
Does anyone knows, if there exists a command to display the correct
Serial-Number of an Cisco-Router ?
Thank you.
Ciao,
Gerhard
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:56 GMT-3