From: Theodore TZEVELEKIS (theodore_tzevelekis@xxxxxxxxx)
Date: Tue May 22 2001 - 13:32:30 GMT-3
But how will the router know which local peer corresponds to which remote
peer?
All dlsw config is done in global config.
I have found the following:
http://www.cisco.com/warp/public/cc/pd/ibsw/ibdlsw/prodlit/dlsw3_rg.htm
(Port List section)
But it is not the exact scenario I'm looking for: This is a 1 & 2 scenario.
1 local peer, 2 physically distinct remote peers.
-----Original Message-----
From: Padhu (LFG) [mailto:padhu@steinroe.com]
Sent: Tuesday, May 22, 2001 5:41 PM
To: 'RAMIL'; Theodore TZEVELEKIS; ccielab@groupstudy.com
Cc: gorrior@yahoo.com
Subject: RE: 2 dlsw peers. On both you have Ethernet and TR
Just my 2c
R1--------------R2
ETh ETH
TR TR
On R1 and R2 , assign ip to ETH and TR interfaces and complete the dlsw
configurations
create a bridge group for ETh and Ring list for TR on both R1 and R2
respectively.
Create the remote peers on R1 with bgroup as the local target pointing to
R2's ethernet as peer
repeat this 3 more times for the 3 other interfaces.
Somone correct me if this wouldn't work.
Cheers,Padhu
-----Original Message-----
From: RAMIL [mailto:ramil@SkiBuff.com]
Sent: Tuesday, May 22, 2001 10:35 AM
To: Theodore TZEVELEKIS; ccielab@groupstudy.com
Cc: gorrior@yahoo.com
Subject: Re:
border peers?
----- Original Message -----
From: "Theodore TZEVELEKIS" <theodore_tzevelekis@yahoo.com>
To: <ccielab@groupstudy.com>
Cc: <gorrior@yahoo.com>
Sent: Tuesday, May 22, 2001 11:28 AM
> Suppose you have 2 dlsw peers. On both you have
> Ethernet and TR.
>
> However, you only want the 2 ethernets to communicate
> with eachother and the two TR with eachother.
>
> In other words, no TR traffic should be seen on either
> ethernet and no ethernet traffic should be seen on
> either TR.
>
> Any ideas about how to do this?
>
> Please reply to all.
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:48 GMT-3