From: John Huston (jhuston@xxxxxxxxxxx)
Date: Fri May 18 2001 - 12:37:14 GMT-3
Probably need to look at which channels you are suppose to be riding on
your t1.
The line of code to consider is
service-module T1 timeslots x-x
> -----Original Message-----
> From: Martin, Chris [mailto:chris@pacinter.net]
> Sent: Friday, May 18, 2001 10:29 AM
> To: Jeongwoo Park; ccielab@groupstudy.com
> Subject: Re: point to point T1 troubleshooting.
>
>
> configs please
>
> ----- Original Message -----
> From: "Jeongwoo Park" <jpark@wams.com>
> To: <ccielab@groupstudy.com>
> Sent: Friday, May 18, 2001 7:58 AM
> Subject: point to point T1 troubleshooting.
>
>
> > Hi all
> > Have anyone troubleshootted T1?
> > it is ppp encapsulation, leased line.
> > LEC(local exchange carrier) said circuit is fine, which I doubt.
> > Router config is fine, I believe.
> > here is output of "sh int s2/0"
> >
> >
> > #sh int s2/0
> > Serial2/0 is up, line protocol is down
> > Hardware is M4T
> > Description: Leased Line to branch
> > Internet address is 10.10.14.86/30
> > MTU 1500 bytes, BW 2048 Kbit, DLY 20000 usec,
> > reliability 255/255, txload 1/255, rxload 1/255
> > Encapsulation PPP, crc 16, loopback not set
> > Keepalive set (10 sec)
> > LCP Listen
> > Closed: IPCP, CDPCP
> > Last input never, output 00:00:03, output hang never
> > Last clearing of "show interface" counters 18:08:32
> > Input queue: 0/75/0 (size/max/drops); Total output
> > drops: 0
> > Queueing strategy: weighted fair
> > Output queue: 0/1000/64/0 (size/max
> > total/threshold/drops)
> > Conversations 0/1/256 (active/max active/max
> > total)
> > Reserved Conversations 0/0 (allocated/max
> > allocated)
> > 5 minute input rate 0 bits/sec, 0 packets/sec
> > 5 minute output rate 0 bits/sec, 0 packets/sec
> > 0 packets input, 0 bytes, 0 no buffer
> > Received 0 broadcasts, 0 runts, 2368 giants, 0
> > throttles
> > 8940 input errors, 1913 CRC, 0 frame, 6028
> > overrun, 0 ignored, 999 abort
> > 13556 packets output, 189784 bytes, 0 underruns
> > 0 output errors, 0 collisions, 3438 interface
> > resets
> > 0 output buffer failures, 0 output buffers
> > swapped out
> > 3672 carrier transitions DCD=up DSR=up
> > DTR=up RTS=up CTS=up
> > **Please read:http://www.groupstudy.com/list/posting.html
> **Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:45 GMT-3