From: Andrew Lennon (andrew.lennon@xxxxxxxxxxxxx)
Date: Thu May 17 2001 - 15:28:14 GMT-3
hat should be
Break into the router upon power up.
Type o/r 0x2142
then reload
-----Original Message-----
From: Andrew Lennon
Sent: 17 May 2001 19:29
To: 'Gupta Sudhanshu SG'; 'ccielab@groupstudy.com'
Subject: RE: IOS upgrade
Gupta,
Break into the router upon power up.
Type o/r 0x2412
then reload
Router should now be in boot mode.
say no to prompts
go into config, and type
router(boot)> no partition flash
Reboot the box,
upon reload,
go to enable mode and
wr mem
conf t
config-reg 0x2012
exit
wr
then copy your new ios
Hope that helps
andy
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Gupta Sudhanshu SG
Sent: 17 May 2001 18:59
To: ccielab@groupstudy.com
Subject: IOS upgrade
Hi team,
we have a router that has quite a historical IOS. It runs on 9.14. (Please
don't laugh at that). We are trying to upgrade it to 12.0.9. It needs 16Mb
flash and 6MB RAM. We have upgraded flash to 16Mb and RAM is also adequate.
Sh ver gives
3000 Software (IGS-BFPX), Version 9.14(9), RELEASE SOFTWARE (fc1)
Patchlevel = 9.1(12.6)
Copyright (c) 1986-1994 by cisco Systems, Inc.
Compiled Wed 28-Sep-94 13:39 by chansen
System Bootstrap, Version 4.14(9.1), SOFTWARE
AVMIL01 uptime is 28 weeks, 18 hours, 29 minutes
System restarted by power-on
System image file is "igs-bfpx.914-9", booted via flash
cisco 2500 (68030) processor (revision A) with 16380K/2048K bytes of memory.
Processor board serial number 01257716
DDN X.25 software, Version 2.0, NET2 and BFE compliant.
Bridging software.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
1 Ethernet/IEEE 802.3 interface.
2 Serial network interfaces.
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash partition 1 (Read ONLY)
8192K bytes of processor board System flash partition 2 (Read/Write)
Configuration register is 0x2102
Once I upload the new image it does not let me do anything. It hangs in
between and when I reload the older imgae it comes up again fine.
Any clues on this.
Thanks
-sudhanshu
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:44 GMT-3