NLSP over ATM

From: Ken Yeo (kenyeo@xxxxxxxxx)
Date: Sun May 13 2001 - 14:09:41 GMT-3

• Next message: zhutong: "Re: authentication cia ripV2 with key-chains"
• Previous message: Jeff Kimes: "RE: OSPF: area 0 authentication and the virtual-link"
• Next in thread: Ken Yeo: "RE: NLSP over ATM"
• Maybe reply: Ken Yeo: "RE: NLSP over ATM"
• Maybe reply: Ken Yeo: "RE: NLSP over ATM"
• Maybe reply: Ken Yeo: "RE: NLSP over ATM"
• Maybe reply: Ken Yeo: "RE: NLSP over ATM"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Anyone tried NLSP over ATM yet?

I couldn't setup NLSP over ATM, there are two issues:

1. NLSP must run in Point to Point subinterface. IOS does not allow me to
setup Full NSAP or ESI addresses on ATM Point to Point subinterface. So I
only have one option, use PVC.

2. IOS does not allow me to setup map-group in ATM point to point
subinterface. So I am stuck. I can setup NLSP but there is not Layer 3 (IPX)
to Layer 2 (ATM VC) mapping.

Any ideas?

Thanks,
Ken Yeo

----
r14(config-subif)#atm nsap-address 1000000000000000000000000000000000000200
ATM: cannot configure NSAP on point-to-point sub-interfaces.
r14(config-subif)#atm esi-address 00000000000001
ATM: cannot configure ESI/NSAP on point-to-point sub-interface.
r14(config-subif)#map-group svcipx3
ATM: cannot configure map-group on point-to-point sub-interface.
r14(config-subif)#
**Please read:http://www.groupstudy.com/list/posting.html

• Next message: zhutong: "Re: authentication cia ripV2 with key-chains"
• Previous message: Jeff Kimes: "RE: OSPF: area 0 authentication and the virtual-link"
• Next in thread: Ken Yeo: "RE: NLSP over ATM"
• Maybe reply: Ken Yeo: "RE: NLSP over ATM"
• Maybe reply: Ken Yeo: "RE: NLSP over ATM"
• Maybe reply: Ken Yeo: "RE: NLSP over ATM"
• Maybe reply: Ken Yeo: "RE: NLSP over ATM"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:40 GMT-3