From: louie kouncar (lkouncar@xxxxxx)
Date: Fri May 11 2001 - 08:49:46 GMT-3
Chun,
There is more than one way of doing this, I prefer the following:
On R1 create a lo int from lets say a class C network (210.1.1.1/24)
then you need to redistribute that into IGRP by using the redistribute
connected command.
at this point the 210.1.1.0 network will show up in the routing table of R2.
Now,
to allow R2 to use this as it's gateway of last resort you need to issue the
following command on R1 in global mode
Ip default-network 210.1.1.0
>From there you will be set.........
Hope this helps.......
Louie J. Kouncar
TCO3 Senior Data Center Engineer
UUNET
W-703-343-6645
C-703-304-2460
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Chun-Yu Chen
Sent: Friday, May 11, 2001 5:41 AM
To: ccielab
Subject: default information redistribute to igrp problem
Dear all,
How can i redistrbute default information via ospf to igrp ?
The sceniro as following,
R1 and R3 are ospf area.
Between R1 s0 and R2 s0 Connect to each other running igrp.
How can i general default-route via R1 to R2.
__ospf____R1___igrp____R2
|
| ospf
R3
Thanks
Regards
Jerry
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:38 GMT-3