From: Brian Dennis (brian@xxxxxx)
Date: Sun May 06 2001 - 21:48:43 GMT-3
You can configure your 2509's e0 interface to get it's IP address via DHCP
(see link below). That would be your NAT outside interface but what
interface are you going to use to connect to your internal LAN (inside
interface)? Serial to another router?
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121newft/121
t/121t2/dt_dhcpc.htm
Brian Dennis, CCIE #2210 (R&S)(ISP/Dial) CCSI #98640
5G Networks, Inc.
brian@5g.net
(925) 260-2724
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> Deepak Puranik
> Sent: Sunday, May 06, 2001 5:07 PM
> To: ccielab@groupstudy.com
> Subject: DHCP Client
>
>
> Hi ..
>
> I have a cable modem and I want to use a Cisco 2509 router as a NAT
>
> box. Can the Ethernet port be configured to accept an IP address from the
> providers DHCP server?
>
> If any one has sample Config, please send to me
>
> Deep
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:35 GMT-3