From: Wayne Gustavus (wgustavus@xxxxxxxxxxxxxx)
Date: Fri May 04 2001 - 14:48:12 GMT-3
Johnny,
It is a little difficult to tell from the ascii net diagram, but if I
interpret what you are trying to do correctly, then you need to insure the
following:
1- RA and RC have 'bridge 1 route ipx'
2- RA and RC have ipx network command on the BVI (instead of the loopback)
3- The BVI is the *router* interface that you want to ping; this means
you'll need to determine what the node/mac of the BVI interface is on each
side so that you can ping.
Of course this is slightly easier to test with IPX workstations attached at
either end, but in the absence of such devices you should be able to test
using the criteria above.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:34 GMT-3