From: C H (craig.hamilton@xxxxxxxxxxxxxx)
Date: Thu May 03 2001 - 05:33:08 GMT-3
Andrew,
This drove me mad the other day, then I had a brain wave.
On R2 set the escape-sequence to look for say Ctrl+P and X, that way when
you telnet to R3 from R2 and press Ctrl+P and X then only R2 will interpret
the Ctrl+P x Escape sequence R1 will ignore Ctrl+P and X as it is looking
for Ctrl+Shift and X.
To set R2 for an escape sequence of Ctrl+P and X type one of two commands:
* Global config mode terminal escape-character 16
or
* Line vty 0 4 escape-character 16
Let me know how you get on.
Regards,
Craig
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
andrew.2.shore@bt.com
Sent: 03 May 2001 08:46
To: ccielab@groupstudy.com
Subject: telnet -> telnet -> telnet
Gang
R1 ----> R2 ----> R3
If I have three routers and telnet from R1 to R2 then reverse telnet to R3
is there a way to get back to R2. For security reasons it is not possible to
telnet directly to R2.
CNTR Shift 6 X takes me back to R1 !
I have a real world situation where I need to use R2 (terminal server) to do
config work on 48 new devices and just flicking between them would make life
so much easier.
Thanks,
Andrew Shore
BTcd
Information Systems Engineering
Internet & Multimedia
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:33 GMT-3