From: Jose Ferreira (jvf@xxxxxxxxx)
Date: Fri Apr 20 2001 - 10:19:37 GMT-3
You will need to do the following on your config (in-line):
router isis <--------------- Do not use the OSI tag, for IP only
routing you don't need that and you have one more opportunity to do a
mistake (like you did bellow)
net 49.0001.0000.0000.000a.00
passive loop2 <------------------- This also includes the loopback
address on the ISIS routing process (unlike other protocols, so you don't
need the ip router isis underr the loop2)
Note: to do the passive loop2 command here you will need to first enable
ISIS on at least another interface or the router will scream (for
instance, do ip router isis on e0 and then come back to router isis and
do passive loop2)
!
int e0
ip add 192.2.2.1 255.255.255.0
ip router isis (no gerald here)
!
loop 2
ip add 13.3.3.3 255.255.255.0
(no ip router isis here)
r2
router isis (you had gerlad here - diferent OSI tag the 2 routers
won't talk)
net 49.0001.0000.0000.000b.00
passive loop2
!
int e0
ip add 192.2.2.2 255.255.255.0
ip router isis (no gerald)
!
loop 2
ip add 14.4.4.4 255.255.255.0
(no ip router isis)
Use: sh isis topo
sh isis data verbose
sh ip route isis (don't forget the distance of ISIS is 115 (IGRP
is prefered over ISIS 8-D ), if you have other routing protocols running
the ISIS routes might not go into the table).
Cheers,
Josi
----- Original Message -----
From: "Jose Ferreira" <jvf@cisco.com>
To: "simplimarvelous" <simplimarvelous@yahoo.com>
Sent: Thursday, April 19, 2001 6:19 PM
Subject: Re: ISIS- any one know how to test isis network after
configured
with basic config
I assume your're configuring ISIS for IP routing right? (CLNS is no
longer
on the LAB).
Try PING like any other routing protocol. ISIS should basically do
the same
as OSPF, although it is encapsulated directly over L2 and the
configuration
is a little bit different than the other routing protocols.
Of course you will need IP addresses on the interfaces.
Regards,
Josi
At 15:51 19/04/01 -0700, you wrote:
>r1
>router isis
> net 22.4444.4444.4444.4444.22
>!
>int e0
> ip router isis
>
>
>
>r2
>router isis
> net 22.4444.4444.4444.4443.22
>!
>int e0
> ip router isis
>
>now what?
>how do i send traffic across?
>
>signed Clue-Less
>
>
>Gerald
>**Please read:http://www.groupstudy.com/list/posting.html
Josi Ferreira
Systems Engineer
Cisco Systems, NSP1 Portugal
Tel: +351 21 446 8728
GSM: +351 91 940 1830
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:52 GMT-3