From: Elias Aggelidis (eaggel@xxxxxxxxxxx)
Date: Thu Apr 19 2001 - 20:44:06 GMT-3
Dear Padhu,
In desktop is not supported.
You are right.
This is something new for me.
IOS still is something that you can not learn by hart I think.
This group is very usefull if you have the time to read all the messages :(
Regards
****************************************************************
Elias Aggelidis ALGOSYSTEMS SA
Senior Network Engineer 4, Sardeon Str
CCNA, CCNP Nea Smyrni
CVOICE, Security Specialised
PICA Administrator
Athens 17121
tel: +301-9310281 GREECE
fax: +301-9352873
email: eaggel@algo.com.gr
****************************************************************
-----Original Message-----
From: Padhu (LFG) [mailto:padhu@steinroe.com]
Sent: ?a?as?e??, 20 ?p?????? 2001 2:33 p5
To: 'Elias Aggelidis'; Carl Phelan; ccielab@groupstudy.com
Subject: RE: Frame Relay Switch with 2 Routers
Pls check your IOS version ...Is it enterprise ? I had 2 routers connected
back to back to provide 4 frame ports untill i got my frame switch . It
should work.
Pls check the archives ..I remember posting a working config sometime ago.
Cheers,Padhu
-----Original Message-----
From: Elias Aggelidis [mailto:eaggel@algo.com.gr]
Sent: Thursday, April 19, 2001 6:12 PM
To: Carl Phelan; ccielab@groupstudy.com
Subject: RE: Frame Relay Switch with 2 Routers
Frame-relay route commands is working only with serials and not with tunnels
!
The correct syntax is
interface serial 0
Frame-relay route 501 interface serial 1 105
interface serial 1
Frame-relay route 105 interface serial 0 501
Hope it helps
****************************************************************
Elias Aggelidis ALGOSYSTEMS SA
Senior Network Engineer 4, Sardeon Str
CCNA, CCNP Nea Smyrni
CVOICE, Security Specialised
PICA Administrator
Athens 17121
tel: +301-9310281 GREECE
fax: +301-9352873
email: eaggel@algo.com.gr
****************************************************************
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of Carl
Phelan
Sent: Paqasjeu^, 20 Apqik_ou 2001 1:40 pl
To: ccielab@groupstudy.com
Subject: Frame Relay Switch with 2 Routers
Hi,
I am following the document from CCprep to create a frame relay switch from
two 2501s. When I come to enter the following command:
'frame-relay route 501 interface t0 105'
in interface mode on Serial 1, the router reports an error in the command
syntax with 't' or even the full word 'tunnel'. When I replace 't0' with a
?
the response is that it only expects the word 'serial'.
I have tried IOS ver 11.1, 11.2 and 12.0 with the same problem on different
routers - anybody have any ideas?
Thanks.
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:52 GMT-3