From: Glen Lavers (glavers@xxxxxxxxx)
Date: Thu Apr 19 2001 - 06:30:23 GMT-3
I think this is what you might be after.
Glen
<<---
R1(HOST)--t/r--R2--DLSw--R3--t/r--R4(PU)
In the above topology R2 and R3 are dlsw peers.
R4 is trying to connect to R1 using LLC2 as
as its transport for SNA..
You can replace the tokenrings with ethernets,
and leave the below config untouched
If you change only one side do not forget the bitswapping :
http://www-tac.cisco.com/TOOLS/Applications/bitswap.html
Sending Router (emulating SNA PU) -> R4
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
dspu host TESTDLSW xid-snd 01712345 rmac 4000.3745.0001 rsap 4 lsap 4
interface TokenRing0
dspu enable-host lsap 4
dspu start TESTDLSW
end
Receiving Router (emulating Mainframe) -> R1
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
dspu pu HOST xid-rcv 01712345
interface TokenRing0
mac-address 4000.3745.0001
dspu enable-pu lsap 4
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Commands to use :
show dlsw peer
show dlsw reach
show dlsw circuit detail
show llc
show rif
show source
debug dlsw core
debug token ring
*****************************************************************
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Devender Singh
Sent: Wednesday, April 18, 2001 10:34 AM
To: Ccielab@Groupstudy. Com (E-mail)
Subject: DLSW: How do generate DLSW traffic from routers.
Can someone guide me how to generate DLSW traffic, so that can do some real
work on dlsw.
thanks in advance.
Devender Singh
BE(Hons), CCNP
IP Solution Specialist
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:50 GMT-3