From: Rob Hopkins (rshopkins@xxxxxxxxxxxxx)
Date: Sun Apr 15 2001 - 01:06:56 GMT-3
If you wanted to have full connectivity, except R2 can only communicate with
Tokenring1
on R1...
ROUTER1
source-bridge ring-group 100 (virtual ring number)
dlsw local-peer peer-id 10.1.1.1
dlsw remote-peer 1 tcp 10.2.2.2 (1=ring list number)
dlsw ring-list 1 rings 35
dlsw ring-list 2 rings 25 35 100
int Tokenring0
source-bridge active 25 1 100 (local ring, bridge, virtual ring number)
source-bridge spanning
int Tokenring1
source-bridge active 35 1 100 (local ring, bridge, virtual ring number)
source-bridge spanning
---------------------------------------------------------------------
ROUTER2
dlsw local-peer peer-id 10.2.2.2
dlsw remote-peer 0 tcp 10.1.1.1 (0=ring list number)
dlsw bridge-group 1
int e0
bridge-group 1
bridge 1 protocol ieee
----- Original Message -----
From: "Atif Awan" <atifawan@hotmail.com>
To: <tariq_sharif@btinternet.com>; <ccielab@groupstudy.com>
Sent: Sunday, April 15, 2001 1:12 AM
Subject: Re: DLSw+ & Ring-Lists
> I think you wanted to say that R2 only needs to communicate with one of
the
> token interfaces on R1. Yes this can be achieved by defining a ring list
on
> R1 :
>
> dlsw ring-list 1 rings 1
>
> and then apply this ring-list to the remote peer statement for R2 :
>
> dlsw remote-peer 1 tcp ip-of-R2
>
>
> Regards
> Atif Awan
>
> >From: "Tariq Sharif" <tariq_sharif@btinternet.com>
> >Reply-To: "Tariq Sharif" <tariq_sharif@btinternet.com>
> >To: "Ccielab@Groupstudy. Com" <ccielab@groupstudy.com>
> >Subject: DLSw+ & Ring-Lists
> >Date: Sat, 14 Apr 2001 22:37:23 +0100
> >
> >I'm trying to set-up DLSw+ between 2 routers. R1 has 2 token ring
> >interfaces
> >& connects to R2 over a serial link. R2 has an ethenet interface. I want
R1
> >to receive traffic from ONLY one of R2's token ring interfaces. If I
place
> >a ring-list on the required token ring interface of R1 will this achieve
> >what I want? Any good references would be appreciated.
> >
> >Many thanks & regards.
> >
> >Tariq Sharif
> >
> >[GroupStudy.com removed an attachment of type application/ms-tnef which
had
> >a name of winmail.dat]
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:45 GMT-3