From: Greg Ferro (gferro@xxxxxxxxxxxxxxxxxxx)
Date: Sun Apr 08 2001 - 06:24:05 GMT-3
This usually means that it is the default. So it doesn't show in the config.
At 11:42 PM 7/04/2001, you wrote:
>Dear all,
>
>I am practicing SNMP configuration now.
>
>There have been several threads on how to limit access to the ARP/IP
>routing table.
>
>So I entered the following config:
>
>snmp-server view view_1 internet included
>snmp-server view view_1 ipRouteTable excluded
>snmp-server view view_1 ipNetToMediaPhysAccess excluded
>
>to give polling access to everything but the the abovementionned tables.
>
>All three commands were accepted, w/o the bad-looking "bad OID"
>
>Looking at the config (even after a "wr"), I could only find out the
>following command:
>
>
>snmp-server view view_1 internet included
>
>=> the two later lines seems not to be included!!
>
>II tried several variations (do no include the first line, different
>order), but the two last lines were never to be seen in the "sh run".
>
>Any idea?
Regards
Greg Ferro | |
Senior Network Engineer, CCIE #6920, CCNP ||| |||
NetStar Australia Pty Ltd. .|||||. .|||||.
9 Mayneview Street, Milton, 4064 .:|||||||||:.:|||||||||:.
GPO Box 166, Brisbane, 4001 C i s c o S y s t e m s
Ph: +61 7 3858 3858; Fax: +61 7 3858 3838 Certified Gold Partner
"Enthusiam and desire is good, knowledge and experience is better"
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:42 GMT-3