From: Tariq Sharif (tariq_sharif@xxxxxxxxxxxxxx)
Date: Sun Apr 01 2001 - 14:24:33 GMT-3
Has anyone played with RSH command. some text say that you need to have
"username admin1..." on the RSH server router but I've got it working
without that (see config below). Any ideas?
Many thanks & regards.
Tariq Sharif
RSH Server Router:
hostname wg1r2
!
ip rcmd rsh-enable
ip rcmd remote-host admin1 222.222.222.222 wg1r1 enable
!
end
RSH test Client:
hostname wg1r1
!
ip rcmd source-interface Loopback300
!
interface Loopback300
ip address 222.222.222.222 255.255.255.0
!
end
wg1r1#rsh 140.1.11.5 /user admin1 sho int loop1
Loopback1 is up, line protocol is up
Hardware is Loopback
MTU 1514 bytes, BW 8000000 Kbit, DLY 5000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation LOOPBACK, loopback not set
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/0, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
wg1r1#
[demime 0.98b removed an attachment of type application/ms-tnef which had a nam
e of winmail.dat]
**NOTE** All LAB SWAP messages should now be sent to the
LAB SWAP Message board on groupstudy.com.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:38 GMT-3