From: Vijay Venkatesh (vijay.venkatesh@xxxxxxx)
Date: Tue Feb 27 2001 - 13:41:52 GMT-3
yes ... possible media issue with card in slot 0. try the following
o Erase the pcmcia card and then do a xmodem
o try another slot
o Check the magnetic tip in the slot. Mechanically this sometimes gives
a problem when you insert the card in a hurry
o Beef up your on baord flash and xmodem to the on board
o Change the config register to boot to rommon and change it back.
Sometimes due to a power surge the chip that holds the register
setting goes into a weird state
o Check to see if your onboard flash is inserted properly ... all pins
match up
Vijay.
MASK wrote:
>
> hi guys,
>
> My 3640 router, which was functioning like champ till
> yesterday, is now, going continuously into ROMMON
> mode, i dunno what the heck with it, following is the
> error output from 3640 console.
> ===============
> System Bootstrap, Version 11.1(20)AA2, EARLY
> DEPLOYMENT RELEASE SOFTWARE (fc1)
> C3600 processor with 32768 Kbytes of main memory
> Main memory is configured to 64 bit mode with parity
> disabled
>
> loadprog: bad file magic number: 0x0
> boot: cannot load "flash:"
> ===============
> and i've tried putting a valid 3640 image in
> slot0:/slot1:, but it gives the same error message
> with slot0:/slot1: mentioned.
>
> i.e.,
> ================
>
> System Bootstrap, Version 11.1(20)AA2, EARLY
> DEPLOYMENT RELEASE SOFTWARE (fc1)
> C3600 processor with 32768 Kbytes of main memory
> Main memory is configured to 64 bit mode with parity
> disabled
>
> device does not contain a valid magic number
> boot: cannot open "slot0:"
> boot: cannot determine first file name on device
> "slot0:"
> =================
>
> Someone plz help me out!!!!
>
> Thx
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:07 GMT-3