From: MASK (afaqk@xxxxxxxxxxxxxx)
Date: Sun Feb 25 2001 - 08:57:36 GMT-3
hi all,
I've a little voip prob., actually i've installed a
VIC-2FXS card on 3640, and loaded it with IOS image
12.0(4)T, but when i go into dial-peer mode, i dont
find "port slot/unit/port#" command, and other thing
is that LEDs on the VIC card are constantly orange!!
i've 32MB(DRAM) and 8MB(flash) on my 3640, BTW , which
IOS image feature set u need to do voip?
Other problem i faced is about ebgp-multihop, what i
observed is that when i use physical interfaces to
configure ebgp multihoping bi-driectionaly(using not-
directly-connected interfaces on both routers to do
peering), neighbors never go to Estab. state, but it
works fine in one direction, ie, when i use
not-directly-connected on one neighbor, and a
directly-conncted on the other, the only way i seem to
do ebgp-multihoping both ways, is to configure ebgp
relationship using loopback interfaces on both the
peering routers. ie.
lo-----(R1)======(R2)-----lo
why it works that way?
Thanks in advance,
bbye
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:00 GMT-3