From: Todd White (towhite@xxxxxxxxx)
Date: Fri Feb 23 2001 - 02:22:59 GMT-3
I am attempting to disable Inverse ARP on a frame relay segment. However, I
am having no luck. Here are the commands I have on the serial interface:
interface Serial0
ip address 150.10.29.2 255.255.255.240
no ip directed-broadcast
ip summary-address eigrp 12 150.10.32.0 255.255.255.0
encapsulation frame-relay
ip split-horizon
ip ospf priority 0
no ip mroute-cache
cdp enable
frame-relay map ip 150.10.29.1 104 broadcast
no frame-relay inverse-arp IP 201
frame-relay lmi-type ansi
After rebooting the router. DLCI 201 still shows up in with the show frame
pvc command as follows:
DLCI = 104, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE = Serial0
input pkts 564 output pkts 814 in bytes 51880
out bytes 117652 dropped pkts 0 in FECN pkts 0
in BECN pkts 0 out FECN pkts 0 out BECN pkts 0
in DE pkts 0 out DE pkts 0
out bcast pkts 244 out bcast bytes 69152
pvc create time 03:59:36, last time pvc status changed 03:59:37
DLCI = 201, DLCI USAGE = UNUSED, PVC STATUS = ACTIVE, INTERFACE = Serial0
input pkts 0 output pkts 239 in bytes 0
out bytes 66442 dropped pkts 0 in FECN pkts 0
in BECN pkts 0 out FECN pkts 0 out BECN pkts 0
in DE pkts 0 out DE pkts 0
out bcast pkts 239 out bcast bytes 66442 Num Pkts Switched 0
Any ideas out there? This seems to follow the documentation but just doesn't
work. Thanks in advance for the help.
Todd
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:58 GMT-3