From: Bernard Dunn (dunn@xxxxxxxxx)
Date: Thu Feb 22 2001 - 08:35:08 GMT-3
Tariq,
What are you using for IP routing protocol?
Can you use extended ping with the peer IP address as source/destination?
On Thu, 22 Feb 2001, Tariq Sharif wrote:
> Using the following config & 2 PCs with NetBue browsing each other I can't
> get it to work. However, when I use "bridge-group 1" on both S0 it does
> work. But according to the text I'm using (Caslow) this line is not at S0
> only used at E0. Should "bridge-group 1" be present at all interfaces?
>
> hostname RouterA
> dlsw local-peer peer-id 132.146.252.1
> dlsw remote-peer 0 tcp 132.146.251.1
> dlsw bridge-group 1
>
> interface Ethernet0
> ip address 132.146.252.1 255.255.255.0
> bridge-group 1
>
> interface Serial0
> ip address 132.146.250.2 255.255.255.0
> clock rate 400000
>
> bridge 1 protocol ieee
>
> hostname RouterB
> dlsw local-peer peer-id 132.146.251.1
> dlsw remote-peer 0 tcp 132.146.252.1
> dlsw bridge-group 1
>
> interface Ethernet0
> ip address 132.146.251.1 255.255.255.0
> bridge-group 1
>
> interface Serial0
> ip address 132.146.250.1 255.255.255.0
>
> bridge 1 protocol ieee
>
> Many thanks & regards.
>
> Tariq Sharif
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:56 GMT-3