From: Tariq Sharif (tariq_sharif@xxxxxxxxxxxxxx)
Date: Thu Feb 22 2001 - 07:48:34 GMT-3
Using the following config & 2 PCs with NetBue browsing each other I can't
get it to work. However, when I use "bridge-group 1" on both S0 it does
work. But according to the text I'm using (Caslow) this line is not at S0
only used at E0. Should "bridge-group 1" be present at all interfaces?
Many thanks & regards.
Tariq Sharif
hostname RouterA
dlsw local-peer peer-id 132.146.252.1
dlsw remote-peer 0 tcp 132.146.251.1
dlsw bridge-group 1
interface Ethernet0
ip address 132.146.252.1 255.255.255.0
bridge-group 1
interface Serial0
ip address 132.146.250.2 255.255.255.0
clock rate 400000
bridge 1 protocol ieee
hostname RouterB
dlsw local-peer peer-id 132.146.251.1
dlsw remote-peer 0 tcp 132.146.252.1
dlsw bridge-group 1
interface Ethernet0
ip address 132.146.251.1 255.255.255.0
bridge-group 1
interface Serial0
ip address 132.146.250.1 255.255.255.0
bridge 1 protocol ieee
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:56 GMT-3