From: Dave and MarySue Nadler (dmnadler1@xxxxxxxx)
Date: Sun Feb 18 2001 - 15:30:42 GMT-3
I have found all of my dialer problems are resolved when I use PPP auth
chap.
Dave
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Elton Fontaine
Sent: Sunday, February 18, 2001 1:24 PM
To: ccielab@groupstudy.com
Subject: ISDN Dialer Profile problems
I had this configuration working when I was only using dialer profile 1 for
IP. Once I added Dialer profile 2 for IPX neither IP or IPX worked over the
ISDN circuit.
Below is a copy of my configs and debug output.
Does anyone have any ideas?
The reason given for rejecting the call is "Network congestion tone on".
R3
interface BRI0
no ip address
no ip directed-broadcast
encapsulation ppp
dialer pool-member 1
isdn switch-type basic-ni
isdn spid1 0146710010
isdn spid2 0146710020
no cdp enable
ppp multilink
!
interface Dialer1
ip address 172.168.65.1 255.255.255.0
no ip directed-broadcast
encapsulation ppp
no ip route-cache
ip ospf interface-retry 0
no ip mroute-cache
dialer remote-name router5
dialer idle-timeout 30
dialer string 4672001
dialer pool 1
dialer-group 1
no peer neighbor-route
ppp multilink
!
interface Dialer2
no ip address
no ip directed-broadcast
encapsulation ppp
dialer remote-name router5ipx
dialer idle-timeout 30
dialer string 4672001
dialer pool 1
dialer-group 2
ipx network 35
no ipx route-cache
ipx update interval rip 20
ipx watchdog-spoof
ipx spx-spoof
ppp multilink
access-list 901 deny any any 457
access-list 901 deny any any rip
access-list 901 deny any any sap
access-list 901 permit any
dialer-list 1 protocol ip permit
dialer-list 2 protocol ipx list 901
*********************************************
R5
interface BRI0
no ip address
no ip directed-broadcast
encapsulation ppp
dialer pool-member 1
isdn switch-type basic-ni
isdn spid1 0146720010
isdn spid2 0146720020
no cdp enable
ppp multilink
!
interface Dialer1
ip address 172.168.65.2 255.255.255.0
no ip directed-broadcast
encapsulation ppp
no ip route-cache
ip ospf interface-retry 0
ip ospf demand-circuit
no ip mroute-cache
dialer remote-name router3
dialer idle-timeout 30
dialer string 4671001
dialer pool 1
dialer-group 1
no peer neighbor-route
ppp multilink
!
interface Dialer2
no ip address
no ip directed-broadcast
encapsulation ppp
dialer remote-name router3ipx
dialer idle-timeout 30
dialer string 4671001
dialer pool 1
dialer-group 2
ipx network 35
no ipx route-cache
ipx update interval rip 20
ipx watchdog-spoof
ppp multilink
!
************************************************
Debug isdn event / Debug isdn q931 output from r3 (output same on both
routers
*Mar 1 16:19:25.903: ISDN BR0: Outgoing call id = 0x8010
*Mar 1 16:19:25.907: ISDN BR0: Event: Call to 4672001 at 64 Kb/s
*Mar 1 16:19:25.919: ISDN BR0: TX -> SETUP pd = 8 callref = 0x10
*Mar 1 16:19:25.919: Bearer Capability i = 0x8890
*Mar 1 16:19:25.923: Channel ID i = 0x83
*Mar 1 16:19:25.927: Keypad Facility i = '4672001'
*Mar 1 16:19:25.999: ISDN BR0: RX <- CALL_PROC pd = 8 callref = 0x90
*Mar 1 16:19:26.003: Channel ID i = 0x89
*Mar 1 16:19:26.003: Signal i = 0x05 - Confirm tone on
*Mar 1 16:19:26.019: ISDN BR0: received HOST_PROCEEDING call_id 0x8010
*Mar 1 16:19:30.431: ISDN BR0: RX <- DISCONNECT pd = 8 callref = 0x90
*Mar 1 16:19:30.435: Cause i = 0x8095 - Call rejected
*Mar 1 16:19:30.439: Signal i = 0x03 - Network congestion tone on
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:52 GMT-3