From: McCoy, Jeffery (jmccoy@xxxxxxxxxxxxxxxxx)
Date: Thu Feb 15 2001 - 17:11:15 GMT-3
** Im afraid that this may have gotten lost in the OT
** conversations....please forgive the repost...
I have completeed this lab sucessfully...I think...I have reachability
everywhere at least, but I have one question.
Section 6, Task 1, number 2 says to 'add r2's eth to the dlsw network.
Make sure there is connectivity between all lan interfaces.'
How do you make sure of this...I know that I have all the interfaces in
the dlsw interface with either a bridge-group statement or a
source-bridge statement, but how do you make sure there is connectivty?
I have verified that there is a connected peer between the routers, but
no circuits will establish because there are no end stations... Also,
these same lan interfaces are also participating in ospf and bgp
routing. I am assuming ip traffic would be routed then and non-routable
protocols would be bridged between these lan interfaces...is that
correct?
Thanks.
-jeff
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:50 GMT-3