From: McCoy, Jeffery (jmccoy@xxxxxxxxxxxxxxxxx)
Date: Thu Feb 15 2001 - 10:59:52 GMT-3
I have completeed this lab sucessfully...I think...I have reachability
everywhere at least, but I have one question.
Section 6, Task 1, number 2 says to 'add r2's eth to the dlsw network. Make
sure there is connectivity between all lan interfaces.'
How do you make sure of this...I know that I have all the interfaces in the
dlsw interface with either a bridge-group statement or a source-bridge
statement, but how do you make sure there is connectivty? I have verified
that there is a connected peer between the routers, but no circuits will
establish because there are no end stations... Also, these same lan
interfaces are also participating in ospf and bgp routing. I am assuming ip
traffic would be routed then and non-routable protocols would be bridged
between these lan interfaces...is that correct?
Thanks.
-jeff
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:49 GMT-3