From: Tyler Pomerhn (tpomerhn@xxxxxxxxx)
Date: Thu Feb 15 2001 - 15:54:02 GMT-3
NM-1FE-TX is NOT supported on 2600 series. I've never seen it work in
one, and all of Cisco's literature says it's not supported as well.
You need a "plus" feature set for ISL, and then only supported on 262x,
265x routers - 261x doesn't support it (10Mbps Ethernet cannot support
trunking).
tp
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> Chuck Church
> Sent: Thursday, February 15, 2001 1:17 PM
> To: 'Tariq Sharif'; Ccielab@Groupstudy. Com
> Subject: RE: Is ISL on 2610 possible?
>
>
> Can you assign layer 3 addresses to the subints? Are you
> using a plus FS?
>
> Chuck Church
> CCNP, CCDP, MCNE, MCSE
> Sr. Network Engineer
> Magnacom Technologies
> 140 N. Rt. 303
> Valley Cottage, NY 10989
> 845-267-4000 x218
>
>
> -----Original Message-----
> From: Tariq Sharif [mailto:tariq_sharif@btinternet.com]
> Sent: Thursday, February 15, 2001 12:51 PM
> To: Ccielab@Groupstudy. Com
> Subject: Is ISL on 2610 possible?
>
>
> Has anyone got ISL on 2610 working? Fastether NM is
> recognized & commands
> (int f1/0.1, encap isl 1 etc) accepted but can't do router on
> a stick VLAN
> interrouting.
>
> Have got the same card working in 3620 (same configs). Just
> curious if poss
> on 2610. Cisco web says can't, but commands are picked up....
>
> Many thanks & regards.
>
> Tariq Sharif
>
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:50 GMT-3