From: Chris Mott (cmott@xxxxxxxx)
Date: Mon Feb 12 2001 - 03:30:33 GMT-3
Not from the command line, but two analog phones will work ... assume that
your card is in slot 0, so your ports are:
voice-port 0/0
!
voice-port 0/1
!
now design two dial-peers that point from one to another:
dial-peer voice 1 pots
destination-pattern 111 <-- this is your phone number
port 0/0
dial-peer voice 2 pots
destination-pattern 222
port 0/1
may not be what you're wanting ... NetMeeting is more involved, but this'll
start you on the way ... HTH
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
chenriqu
Sent: Sunday, February 11, 2001 11:16 PM
To: ccielab@groupstudy.com
Subject: VOIP
Hello,
Here is the situation I have one FXS card in one of my routers. Is there a
way to Dial a FXS port from the command line in the Cisco IOS. Not sure if I
am saying this right but I hope someone understands what I mean.
Thanks
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:45 GMT-3