Cisco 2501 and modem connection

From: Sam Pilot (sam_pilot@xxxxxxxxxxx)
Date: Sun Feb 11 2001 - 18:52:37 GMT-3

• Next message: chenriqu: "RE: Any limitations with Catalyst 2901 as opposed to Cat5000?"
• Previous message: Adrian Chew: "Re: Any limitations with Catalyst 2901 as opposed to Cat5000?"
• Next in thread: Andrew: "Re: Cisco 2501 and modem connection"
• Maybe reply: Andrew: "Re: Cisco 2501 and modem connection"
• Maybe reply: Thomas Alexander: "Re: Cisco 2501 and modem connection"
• Maybe reply: Steven Weber: "Re: Cisco 2501 and modem connection"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Hello folks

I have a 2511 terminal server which I am using to reverse telnet into a =
2501 router. This router has a modem connected to the Aux port.

I have configured the Aux port so that I can reverse telnet into the =
modem (using the "modem inout" command) so that I can configure it.=20

I am able to get into the modem and use the AT command set.

My question is how to get back out of the modem configuration mode and =
back to my 2501 router. If I do Ctrl Shift 6 X, I come back to the =
terminal server prompt.

Any suggestions?

Thanks

Sam

• Next message: chenriqu: "RE: Any limitations with Catalyst 2901 as opposed to Cat5000?"
• Previous message: Adrian Chew: "Re: Any limitations with Catalyst 2901 as opposed to Cat5000?"
• Next in thread: Andrew: "Re: Cisco 2501 and modem connection"
• Maybe reply: Andrew: "Re: Cisco 2501 and modem connection"
• Maybe reply: Thomas Alexander: "Re: Cisco 2501 and modem connection"
• Maybe reply: Steven Weber: "Re: Cisco 2501 and modem connection"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:45 GMT-3