From: Patrick Bikar (pbikar@xxxxxxxxx)
Date: Fri Feb 09 2001 - 07:39:20 GMT-3
Hi Perry,
It is not required to configure bridge-group to have LAM working : the doc
CD is misleading for this.
Check out :
http://www.mentortech.com/learn/welcher/papers/mobileip.html
Cheers,
Patrick.
At 14:14 09/02/2001 +0800, zhuqingliu wrote:
>Hi,
>
> According to the cisco CD, Local area mobility configuration need the
> following step:
> 1. enable proxy arp (default enabled)
> 2. enable ip mobile arp
> 3. redistirbute mobile host route in an routing protocol
> 4. enable bridge under interface
>!**********************************
>bridge 1 protocol ieee
>access-list 10 permit 192.100.100.55
>interface ethernet 0
> ip mobile arp access-group 10
> bridge-group 1
>router eigrp 100
> redistribute mobile metric 10 2000 255 1 1500
>!************************************
>
> But in my lab, w/o the "bridge-group 1" command LAM works correctly.
> Am I missing something?
>
>Best regards
>Perry.Zhu
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:43 GMT-3