From: Peter Puczko (ppuczko@xxxxxxxxxx)
Date: Fri Feb 09 2001 - 01:19:37 GMT-3
Where are your "frame-relay interface-dlci xxx" commands under s0.1?
Peter
On Thu, 08 Feb 2001 22:53:58 -0500, Steven Weber wrote:
> I'm having some problems with my config I can't get any of the spokes to
> ping each other any suggestions.Current configuration:
> !
> version 11.2
> !
> hostname r1
> !
> !
> no ip domain-lookup
> ip host r2 2001 10.1.1.100
> ip host r3 2002 10.1.1.100
> ip host r4 2003 10.1.1.100
> ip host r5 2004 10.1.1.100
> ip host r7 2006 10.1.1.100
> !
> interface Loopback0
> ip address 10.1.1.100 255.255.255.0
> !
> interface Ethernet0
> ip address 10.100.100.1 255.255.0.0
> no keepalive
> !
> interface Serial0
> no ip address
> encapsulation frame-relay
> ip ospf priority 10
> !
> interface Serial0.1 multipoint
> ip address 10.10.1.1 255.255.0.0
> ip policy route-map FRAM
> frame-relay map ip 10.10.1.2 102
> frame-relay map ip 10.10.1.3 103
> frame-relay map ip 10.10.1.5 105
> !
> interface Serial1
> no ip address
> shutdown
> !
> router ospf 1
> network 10.10.0.0 0.0.255.255 area 0
> network 10.100.0.0 0.0.255.255 area 1
> neighbor 10.10.1.3 priority 1
> neighbor 10.10.1.2 priority 1
> neighbor 10.10.1.5 priority 1
> !
> ip classless
> access-list 100 permit ip any 10.10.0.0 0.0.255.255
> access-list 101 permit ip any 10.10.0.0 0.0.255.255
> access-list 102 permit ip any 10.10.0.0 0.0.255.255
> route-map FRAM permit 10
> match ip address 100
> set ip next-hop 10.10.1.2
> !
> route-map FRAM permit 20
> match ip address 101
> set ip next-hop 10.10.1.3
> !
> route-map FRAM permit 30
> match ip address 102
> set ip next-hop 10.10.1.5
> !
> !
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:42 GMT-3